1. Product Specification of the Heat Moldable Orthotics
|Main Material:||Sublimated Graphic Polyester + Red Shock aborption Rubber Foam + High density Rubber Bottom|
U.S. MEN 6# - 12+
EU: 35 - 46#
2. Product Introduction of the Heat Moldable Orthotics
This product provides advanced cushioning for the heel. It can lessens strain on the plantar fascia. And assists in aligning foot to a natural, healthy position. Optimizes Natural Motion™.
Applying heat at the bottom side in the arch area will allow you to either raise or lower the arch. You do this by bending it into the desired way (increase or decrease) then holding it there until it cools down a bit. You should only heat it up 30 seconds or so. Depends on how hot your heat gun gets. If it is to hot for you to touch it you heated to much.
Molding instructions included in the packaging.