1.Moldable Shoe Inserts
Sublimated Graphic Velvet + Orange Poliyun + Polyester Fabric Bottom + Hot-melt Adhesive for Heatmoldable
U.S. MEN 6# - 12+
EU: 35 - 46#
as shown in the figure
2. Product Introduction of Moldable Shoe Inserts
This is one Heat-moldable Orthotic that is the best choice for sports. If you have any requirements, please consult us.
1.Take out Heat-moldable Orthotics from packaging and set aside.
2.Remove original insole from your footwear. (If glued in,leave them in place.)
3.You may need to trim toe of your Heat-moldable Orthotics with scissors for proper fit-use the original shoe insoles as a guide.
4.Warm up Heat-moldable Orthotic by Hair-dryer at the Bottom heel part.
5.Heat for 3 minutes.
6.Carefully put the Heat-moldable Orthotic into the shoes
7.Step in footwear and stand up straight with toes pointing forward. Do not bend toes.
8.Bend knees slightly to put your feet into a neutral position and stand still for approximately 1 minute.